Table of Contents
Advertisement
INSTALLATION
VIII.INSTALLING THE RE-
MOTE DIAGNOSTIC
DEVICE II
A. Unpacking
w
t
u
Fig. 5-801
RDD ....................................................... 1 unit
Power Supply Unit ................................. 1 unit
Screw (M4 6) ........................................ 4 pcs.
Harness band ........................................ 2 pcs.
Switch setting label ................................ 1 pcs.
Grounding wire* ..................................... 1 pc.
Ferrite core ............................................ 1 pc.
*Not used.
5–28
q
e
r
y
COPYRIGHT © 1998 CANON INC.
B. Installation to the Copier
Caution:
This model may not be available for sale in
some areas.
Caution:
Keep the following in mind when installing the
RDD to the copier:
1. This Accessory is to be installed by a qualified
personal.
2. Make sure the copier has been properly in-
stalled before starting the work.
3. Keep the copier's power cord disconnected
during the work.
4. Be sure to use the appropriate screws (length,
diameter).
5. Make sure the computer in the service station
has been properly loaded with the RDD's set-
tings data.
1) Remove the two screws
top cover
.
w
Fig. 5-802
2) Connect the Power Supply Unit's connector
to the RDD's connector
r
Fig. 5-803
CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
to detach the RDD's
q
w
as shown.
e
Advertisement
Chapters
Table of Contents
