Canon NP6621 Service Manual page 221

6) Remove the mounting screw
and remove the oil damper plate
6
7
Figure 4-355
7) Remove the E-ring
(rear); then, remove the gear
and spring .
9 10
8
Figure 4-356
COPYRIGHT © 1998 CANON INC.
from the front,
.
from the lifter drive shaft
, two washers,
CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
8) Remove the E-ring
, parallel pin, and pulley cover (front/rear in
common).
Figure 4-357
9) Remove the end of the wire from the pulley
(front/rear in common).
10) Remove the fastener
assembly; then, remove the pulley cover, and
remove the wire from the pulley (front/rear in
common).
Figure 4-358
MECHANICAL SYSTEM
; then, remove the gear
11
12
from the wire relay
13
4–29