Canon NP6621 Service Manual page 222

MECHANICAL SYSTEM
11) Remove the mounting screw
the wire together with the mounting support.
14
Figure 4-359
4. Removing the Pick-Up Assembly
1) Open the right door of the pedestal, and slide
out the paper deck to the front about 10 cm.
Caution:
• For the paper deck pedestal, slide out only the
paper deck.
• Do not try to detach the pick-up assembly
without removing the paper deck from the
pedestal; the lifter will make the removal of
the pick-up assembly impossible.
• Do not slide out the paper deck too far toward
the front; doing so would cause the pedestal
to tilt to the front when the pick-up assembly
is removed.
2) Remove the right cover.
3) Remove the screw
plate.
4) Remove the eight mounting screws
remove the two support plates
5) Disconnect the four connectors
3
Figure 4-360
4–30
, and remove
; then, remove the stop
, and
.
.
2
3
4
2
1 4
COPYRIGHT © 1998 CANON INC.
6) Remove the six mounting screws
move the pick-up assembly.
Figure 4-361
5. Removing the Pick-Up Roller
1) Remove the pick-up assembly.
2) Remove the stop ring
up roller together with the roller collar.
2
Figure 4-362
CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
, and re-
5
, and remove the pick-
1