Canon NP6621 Service Manual page 198

MECHANICAL SYSTEM
7) Loosen the two screws
tension (both front and rear).
Figure 4-206
8) Move the No. 1 mirror mount in the forward
direction, and match the angular hole in the
front side panel and the cable fixing screw
Then, remove to separate the No. 1 mirror
mount and the scanner cable (both front and
rear).
(front)
(rear)
Figure 4-207
9) Remove the pulley clip, and remove the scan-
ner cable (both front and rear).
4–6
, and loosen the cable
4
5
COPYRIGHT © 1998 CANON INC.
3. Assembling the Mirror Positioning
Tool
1) Remove the screw from position B.
Longest pin
.
2) Put the screw removed in step 1) to position A;
then, tighten it slightly.
3) Pull the arm out of the main frame, and extend
it until it comes into contact with the stopper as
indicated in Figure 4-209.
4) Tighten the screw.
5
CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Position B
Medium-Length pin
Figure 4-208
Position A
Figure 4-209