Table of Contents
Advertisement
Example 6-3 DSA Preboot: Commands on the update menu
Starting DSA Preboot v1.00
Commands:
update - Update/Recover your embedded usb chip
help - Display this help message
exit - Quit program.
Please enter a command. (Type 'help' for commands)
> update
4. Use the command update.
The flashing of the device starts after a re-init of the USB device, shown in
Example 6-4.
Example 6-4 DSA Preboot: flash progress
> update
Node count: 1
Flashing node: 0
Waiting for device to become available:
.usb 5-6: new high speed USB device using ehci_hcd and address 3
usb 5-6: new device found. idVendor=0483, idProduct=fada
...
usb 5-6: Product: ST72682 High Speed Mode
usb 5-6: Manufacturer STMicroelectronics
scsi1 : SCSI emulation for USB Mass Storage devices
..... Vendor: ST
Type:
SCSI device sda_: 1024000 512-byte hdwr sectors (524 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
sda
sd 1:0:0:0: Attached scsi removable disk sda
sd 1:0:0:0: Attached scsi generic sg1 type 0
Device flashing in progress
....................................................................
....................................................................
....................................................................
....................................................................
DSA key has been flashed successfully
Please enter a command. (Type 'help' for commands)
usb 5-6: USB disconnect, address 3
> _
370
Planning, Installing, and Managing the IBM System x3950 M2
Note: This will reboot the syste,-
Model: ST72682
Direct-Access
Rev: 2.10
ANSI-SCSI revision:02
Advertisement
Table of Contents
