Table of Contents
Advertisement
Figure 3-37 ServeRAID-MR10k code package extraction
4. Boot the server with disks 1, 2, and 3 as prompted. It attempts to flash all
ServeRAID-MR10k or ServeRAID-MR10M controllers in the system. You
might see warning messages stating that this flash is not compatible with all
controllers, as shown in Figure 3-38. These are not error messages.
****************************************
*
*
SAS Firmware & BIOS Flash Disk
*
****************************************
This program will update the firmware on all IBM ServeRAID-MR10k
controllers in the system.
.
Do you wan to continue[Y,N]?_
Figure 3-38 ServeRAID-MR10k: update process
5. Press Y to start the flash process. The update starts, as shown in Figure 3-39
on page 152.
*
*
*
Chapter 3. Hardware configuration
151
Advertisement
Table of Contents
