Table of Contents
Advertisement
This update is for the ServeRAID-MR10k controllers.
Controller 1 is a ServeRAID-MR10k controller.
Attempting to flash controller 1!
Updating firmware on controller 1. Please wait....
Update of controller 1 firmware completed successfully.
Updating BIOS on Controller 1. Please wait....
Update of controller 1 BIOS completed successfully.
Controller 2 is a ServeRAID-MR10k controller.
Attempting to flash controller 2!
Updating firmware on controller 2. Please wait....
Update of controller 2 firmware completed successfully.
Updating BIOS on Controller 2. Please wait....
Update of controller 2 BIOS completed successfully.
C:\>_
Figure 3-39 ServeRAID-MR10M: update process
6. After the update completes, reboot your server.
7. If all updates are performed, go to 3.4, "Configuring RAID volumes" on
page 154.
Updating the SAS hard disk drives
We used the steps in this section to update the controllers.
To update the SAS hard disk drives internal in the media hood assembly and
external in the EXP3000 installed:
1. Download the bootable CD from the following Web address:
http://www.ibm.com/support/docview.wss?uid=psg1MIGR-62832
2. Burn a CD or mount the ISO image in the Remote Supervisor Adapter II
remote drive of the Web interface as described in 6.2.4, "Remote console and
media" on page 324.
3. Boot your server from this CD image.
4. Update the hard drive disks by clicking the Update button.
The update program window is shown in Figure 3-40 on page 153.
152
Planning, Installing, and Managing the IBM System x3950 M2
Advertisement
Table of Contents
