Fiber Specifications - Cisco SFE2000P Installation And Configuration Manual

Connecting the line ports to the network
When installing an External Optical Bypass module, the SCE 2000 line ports are connected to the
Note
module. See
Class 1 laser. Avoid exposure to radiation and do not stare into open aperture.

Fiber Specifications

The following table presents the fiber specifications. The SCE 2000 may be ordered with either
Multimode or Single Mode transceivers The transceiver type is indicated on the front panel under the
ports. Note that both transceivers on any individual SCE 2000 are the same, either 850nm Multimode
OR 1310nm Single Mode.
Table 6-1
SCE Model
SCE 2000 4xGBE
MM
SCE 2000 4xGBE
SM
SUMMARY STEPS
1.
2.
DETAILED STEPS
Step 1 Take the appropriate fiber optic cable (see
port on the front panel of the SCE 2000 .
Make sure to push on the connector until you hear a click, which indicates that the connector is fully
inserted and secured in the receptacle. Always make sure that you insert the connector completely into
the socket.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-8
The External Optical Bypass Module
Fiber Specifications
Transceiver
850nm Multimode –9.5 to –4 dBm
1310nm FRP laser
Single Mode
Take the appropriate fiber optic cable (see
GBE port on the front panel of the SCE 2000.
Verify that the link LED is green.
Chapter 6 Cabling the Line Ports and Completing the Installation
for complete instructions.
Transmit Power Receive Power
–17 to 0 dBm
–9.5 to –3 dBm –20 to 3 dBm
Fiber Specifications
Fiber Specifications ) and plug it into the appropriate GBE
Typical (Max.)
Distance
750m for
•
50µm Core
Diameter
MMF
• 400m for
62.5µm Core
Diameter
MMF
10 km for 9.0µm
Core Diameter
SMF
) and plug it into the appropriate
OL-7824-06