Installation And Maintenance; Information About Preparing To Install The Sce 2000 Platform - Cisco SFE2000P Installation And Configuration Manual

Installation and Maintenance

This chapter explains how to install a SCE 2000 platform in a rack or in a general tabletop or workbench
installation. Additionally, this chapter contains instructions for installing or replacing the power supply
units and fan modules.
Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for the Cisco Service Control Engine . This guide contains important safety information you
should know before working with the system.
•
•
•
•
•
•
•

Information About Preparing to Install the SCE 2000 Platform

Before installing your SCE 2000 platform, you should consider the power and cabling requirements that
must be in place at your installation site, the equipment you need to install the platform, and the
environmental conditions your installation site must meet to maintain normal operation. This section
guides you through the process of preparing for your SCE 2000 platform installation and the installation
in a rack. The section contains the following topics:
•
•
OL-7824-06
Information About Preparing to Install the SCE 2000 Platform
Installing the SCE 2000 Platform
Removing and Replacing a Power Supply Unit
How to Replace the Power Supply Unit
Reconnecting the Power
Fan Module Overview
How to Replace the Battery
Tools and Parts Required
Information About Site Requirement Guidelines
C H A P T E R
Cisco SCE 2000 4xGBE Installation and Configuration Guide
4
4-1