Troubleshooting Aids
Pi n
A 3
A 4
Note
USB TYPE-A receptacle is used.
Note
The USB MEM port +5VDC is output. Cisco ASR 920 Router provides power for USB MEM port. This port
operates as a USB host device.
Check Optical Fiber Specifications
The specification for optical fiber transmission defines two types of fiber: single mode and multimode. Within
the single-mode category, three transmission types are defined: short reach, intermediate reach, and long
reach. Within the multimode category, only short reach is available. For information about optical SFP modules,
see the documentation for the SFP module at:
http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html
Check Alarm Conditions
The following table summarizes the meaning of the alarm conditions on the Cisco ASR 920 Router.
Table 14: Alarm Condition Summary
Alarm
Type
Critical
Major
Info
Check LED Indicators
This section describes the different types of front panel LEDs and their behavior.
Signal
Description
Name
D+
Data +
Gnd
Ground
Alarm Meaning
Port in down state.
Environmental sensor threshold exceeded critical level (voltage, temperature)
Environmental sensor threshold exceeded major level (voltage, temperature)
Port administratively shut down.
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
Check Optical Fiber Specifications
.
69