Cisco SFE2000P Installation And Configuration Manual page 66

How to Set Up the Local Console
Make sure that the terminal configuration is as follows:
•
•
•
•
•
The above SCE 2000 port parameters are fixed and are not configurable.
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Step 1 Plug the RS-232 serial cable provided with the SCE 2000 into the CON port on the front panel of the
SCE 2000 .
Make sure that you push on the RJ-45 connector (attached to the RS-232 serial cable) until you hear a
"click", which indicates that the connector is fully inserted and secured in the receptacle. Gently pull on
the plug to confirm whether the plug is locked into the socket.
Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible
Step 2
local (serial) terminal.
Make sure the local terminal is configured as a VT-100 terminal, according to the fixed SCE 2000 CON
Step 3
port parameters.
Press Enter several times until the Cisco logo appears on the local terminal and the setup configuration
Step 4
dialog is entered.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' followed by 'Enter' for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to continue with the System Configuration Dialog? [yes/no]: y
Type yand press Enter.
Step 5
The system configuration dialog begins.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-2
Chapter 5
9600 baud
8 data bits
No Parity
1 stop bits
No flow control
Plug the RS-232 serial cable provided with the SCE 2000 into the CON port on the front panel of
the SCE 2000 .
Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100
compatible local (serial) terminal.
Make sure the local terminal is configured as a VT-100 terminal, according to the fixed SCE 2000
CON port parameters.
Press Enter several times until the Cisco logo appears on the local terminal and the setup
configuration dialog is entered.
Type yand press Enter.
Connecting the Management Interfaces and Performing Initial System Configuration
OL-7824-06