Cisco SFE2000P Installation And Configuration Manual page 72

Initial System Configuration
•
•
Passwords are needed for all authorization levels in order to prevent unauthorized users from accessing
Note
the SCE 2000 . Admin level should be used by the network administrator. Root level is for use by Cisco
technician.
Passwords must meet the following criteria:
•
•
•
•
Note Passwords are case sensitive.
The default password for all levels is " cisco".
Note
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
The default User password is displayed.
Step 1
•
•
The default Admin password is displayed.
Step 2
•
•
Step 3 The default Root password is displayed.
•
•
Configure password encryption. By default, password encryption is not enabled.
Step 4
•
•
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-8
Chapter 5
Set the password for each authorization level (User, Admin, Root).
Enable/disable password encryption. When password encryption is enabled, it encrypts the
previously entered passwords.
Minimum length — 4 characters
Maximum length — 100 characters
Begin with an alpha character
May contain only printable characters
The default User password is displayed.
The default Admin password is displayed.
The default Root password is displayed.
Configure password encryption. By default, password encryption is not enabled.
To accept the displayed value, press Enter.
To change the value, type any desired character string and press Enter.
To accept the displayed value, press Enter.
To change the value, type any desired character string and press Enter.
To accept the displayed value, press Enter.
To change the value, type any desired character string and press Enter.
To disable password encryption, press Enter.
To enable password encryption, type yand press Enter.
Connecting the Management Interfaces and Performing Initial System Configuration
OL-7824-06