Organization - Cisco SFE2000P Installation And Configuration Manual

Organization

Organization
The major sections of this guide are as follows:
Table 1
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Cisco SCE 2000 4xGBE Installation and Configuration Guide
x
Title
General Overview
Introduction to the SCE Platform
Information About Topology
Installation and Maintenance
Connecting the Management
Interfaces and Performing Initial
System Configuration
Cabling the Line Ports and
Completing the Installation
Basic SCE 2000 Platform
Operations
About this Guide
Description
This chapter provides a brief
introduction to Cisco Service
Control.
This chapter provides a hardware
overview of the SCE 2000
platform.
This chapter describes the
possible deployment topologies
of the SCE 2000 and explains
how various aspects of the
topology determine the
configuration of the system.
This chapter explains how to
install a SCE 2000 platform in a
rack or in a general tabletop
installation and how to install or
replace the power supply units
and fan modules.
This chapter explains how to
connect the SCE 2000 platform
to a local console and perform
the initial system configuration
via the setup wizard that runs
automatically.
This chapter provides
instructions for cabling the
Gigabit Ethernet ports for both
one and two SCE 2000
topologies, and for configuring
Gigabit Ethernet (GBE)
interface parameters. In a
topology utilizing two SCE 2000
s (cascade), this includes the
cascade ports as well as the line
ports.
This chapter describes how to
start up the SCE 2000 platform,
reboot, and shutdown. It also
describes how to manage
configurations.
OL-7824-06