How To Configure The Gbe Interface Parameters; How To Cable The Gbe Line Interface Ports - Cisco SFE2000P Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation

How to Configure the GBE Interface Parameters

By default, the SCE 2000 GBE line interface ports are configured with auto-negotiation disabled. The
procedure for enabling auto-negotiation for the GBE line interface ports is explained in the following
section.
Auto-negotiation must be disabled when the SCE 2000 is deployed via an external optical splitter
Note
(receive-only topology)
If you change any parameters, you must save the new configuration settings. Type
Note
startup-config
The maximum packet size supported by the SCE platform is 1600 bytes
Note
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
To enter the Global Configuration Mode, at the SCE 2000# prompt, type configure, and press Enter.
Step 1
The SCE 2000(config)# prompt appears.
To enter the desired GBE port interface, type interfaceGigabitEthernet 0/ portnumber, and press Enter,
Step 2
where portnumberis the number of the selected port (1-4).
The SCE 2000(config if)# prompt appears.
Type auto-negotiateand press Enter.
Step 3
The SCE 2000(config if)# prompt appears.
To return to Global Configuration Mode, type exitand press Enter.
Step 4
The SCE 2000(config)# prompt appears.
Repeat this procedure to configure auto-negotiation for the other GBE port interfaces as needed.

How to Cable the GBE Line Interface Ports

The following sections present the general procedure for cabling the GBE interface ports. Refer to
Cabling Diagrams
specific connections required.
OL-7824-06
, and press Enter.
To enter the Global Configuration Mode, at the SCE 2000# prompt, type configure, and press Enter.
To enter the desired GBE port interface, type interfaceGigabitEthernet 0/ portnumber, and press
Enter, where portnumberis the number of the selected port (1-4).
Type auto-negotiateand press Enter.
To return to Global Configuration Mode, type exitand press Enter.
to find the appropriate cabling diagram for the topology of your system for the
Connecting the line ports to the network
Cisco SCE 2000 4xGBE Installation and Configuration Guide
copy running-config
6-7