Information About Cascaded Systems; How To Install A Cascaded System - Cisco SFE2000P Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation

Information About Cascaded Systems

•
•

How to Install a Cascaded System

This section outlines the installation procedures for a redundant solution with two cascaded SCE 2000
platforms. Refer to the Cisco Service Control Engine (SCE) CLI Command Reference for details of the
CLI commands.
When working with two SCE 2000 platforms with split-flow and redundancy, it is extremely important
to follow this installation procedure.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
OL-7824-06
How to Install a Cascaded System
CLI Commands for Cascaded Systems
Install both SCE 2000 platforms, power them up, and perform the initial system configuration. (See
Installation and Maintenance
System Configuration.)
Connect both SCE 2000 platforms to the management station. (See
Interfaces and Performing Initial System
Connect the cascade ports. The cascade ports must be connected directly in Layer 1 (dark fibers),
not through switches. (See
Set topology configurations for each SCE 2000 platform via the connection-mode options. (See
Information About Topology-Related
Make sure that the SCE 2000 platforms have synchronized and active SCE 2000 platform was
selected.
If you want to start with bypass/sniffing, change the link mode to your required mode in both SCE
2000 platforms on both links. The bypass mode will be applied only to the active SCE 2000
platform. (See How to Set the Link
Make sure that the link mode is as you required. (See
Connect the traffic port of SCE 2000 platform #1. This will cause a momentary down time until the
network elements from both sides of the SCE 2000 platform auto-negotiate with it and start working
(when working inline). (See
Connect the traffic port of SCE 2000 platform #2. This will cause a momentary down time until the
network elements from both sides of the SCE 2000 platform auto-negotiate with it and start working
(when working inline). (See
When full control is needed, change the link mode on both SCE 2000 platforms on both links to
'forwarding'. It is recommended to first configure the active SCE 2000 platform and then the
standby. (See How to Set the Link
You can now start working with the Subscriber Manager.
and Connecting the Management Interfaces and Performing Initial
Configuration.)
Dual Link: Two SCE 2000s
Parameters.)
Mode.)
Dual Link: Two SCE 2000s
Dual Link: Two SCE 2000s
Mode.)
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Information About Cascaded Systems
Connecting the Management
Topology.)
Monitoring the System.)
Topology.)
Topology.)
6-11