Cisco SFE2000P Installation And Configuration Manual page 74

Initial System Configuration
The local time and date are displayed, and you are asked whether you want to change them.
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
If the time and date are correct, go to .
Step 4
If the time and date are not correct, answer yes to the above question, and press Enter.
Would you like to set a new time and date? [no]: yConfirm your response and type the new
time and date.
This change will take effect immediately both on the system clock and calendar;
it will also set the time zone you entered. Are you sure? [yes/no]: yEnter new local time
and date: 14:00:01 1 July 2002Time zone was successfully set.
The system clock and the calendar were successfully set.
Step 5 You are asked whether you wish to enter the SNTP configuration menu.
If you do not wish to configure the SNTP, skip the rest of this section and go to .
To enter the SNTP configuration dialog, type y, and press
Enter
Would you like to enter the SNTP configuration menu? [no]: y
Step 6 Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
To disable the SNTP broadcast client, press Enter.
•
To enable the SNTP broadcast client, type yand press Enter.
•
Enable SNTP broadcast client? [no]:
Step 7 Define the time interval between unicast updates.
• To accept the displayed default value, press Enter.
To change the value, type the desired number of seconds (64 through 1024) and press Enter.
•
Enter time interval in seconds between unicast updates [1024]:
You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP address in the
Step 8
form x.x.x.x, and press
Enter
Step 9
Would you like to configure SNTP unicast servers? [no]: yEnter IP address or hostname of
SNTP unicast server: 10.1.1.1
EXAMPLE:
Following is a sample time setting dialog. In addition to setting the time zone, time and date are changed,
and SNTP unicast updates are configured.
Would you like to enter the Time settings menu? [no]: yEnter time zone name [UTC]: ISR
Enter time zone minutes offset from UTC: 120The local time and date is 15:35:23 ISR FRI
July 19 2002
Would you like to set a new time and date? [no]: yThis change will take effect immediately
both on the system clock
and the calendar; it will also set the time zone you entered.
Are you sure? [yes/no]: yEnter new local time and date: 14:35:23 19 July 2002Time zone was
successfully set.
The system clock and the calendar were successfully set.
Would you like to enter the SNTP configuration menu? [no]: yEnable SNTP broadcast client?
[no]: yEnter time interval in seconds between unicast updates [900]:
Would you like to configure SNTP unicast servers? [no]: yEnter IP address or hostname of
SNTP unicast server: 10.1.1.1
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-10
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
OL-7824-06