Chapter 2
Introduction to the SCE Platform
Table 2-2
Port
AUX
GBE ports 1-4
Table 2-3
LED Groups
Power A
Power B
Status
OL-7824-06
SCE 2000 Ports
Quantity
1
4
SCE 2000 LED Groups
Description
RS-232 RJ-45 port used
by technicians
GigabitEthernet ports
for connecting to the
line and/or cascading
two devices
CLI designation:
interface
GigabitEthernet 0/1
through 0/4
Description
Continuous green — Power supply A is
•
functioning normally
Red — Power supply A present, but
•
malfunctioning
Unlit — Power supply A is either not present
•
or has failed.
Continuous green — Power supply B is
•
functioning normally
Red — Power supply B present, but
•
malfunctioning
Unlit — Power supply B is either not present
•
or has failed.
The Status LED indicates the operational status of
the SCE 2000 system, as follows:
•
Unlit — indicates no power from either power
unit.
Orange — indicates that the system is booting
•
up.
Flashing green — indicates that the system is
•
fully operational.
•
Flashing orange — indicates that the system is
operational, but is in a warning state.
Red — indicates that there is a problem or
•
failure
Note that Alarms are hierarchical: Failure takes
precedence over Warning, which takes precedence
over operational.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Information About The SCE Platform
Connect This Port To...
2-3