Avaya PARTNER Advanced Communications System Installation And Use Manual page 376

®
PARTNER Advanced Communications System Installation, Programming, and Use
6. Push slowly but firmly in the center of the module until the module locks into place and is
attached to the rear of the carrier. Do not force the module. If the module does not insert
easily, remove it, clear any obstruction, and reinsert it.
7. Connect line and/or extension jack cords to the new module (see
Extensions" on page
8. Reconnect the power cord to the wall outlet.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic
case. Do not install the power cord at an angle to the case or with a loop in it.
9. Move the On/Off switch to the "On" position ("—").
10. Check that all green lights on the fronts of the modules are lit:
If a single light is out, power down the control unit, reseat the module, and power up the
control unit.
If multiple lights are out, power down the control unit, reseat the leftmost module that has
a light out, and power up the control unit.
If the lights are still out, call for support as instructed on the inside front cover of this guide.
11. Make sure all modules are seated properly.
12. If you have Release 4.0 or later:
a. Position the carrier cover over the modules so that the openings on the top of the carrier
cover align correctly with the tabs at the top of the installed 5-slot carrier and modules.
b. Rotate the carrier cover into position so that it aligns correctly with the thumb screw
opening on the bottom of the carrier.
c. Tighten the thumb screw. To ensure proper alignment and safe operation, tighten the
thumb screw securely.
If you have Release 3.0 or earlier:
a. Grasp the cover by its upper edges and hold it squarely over the control unit. Place the
cover over the modules and make sure it fits firmly in place.
b. Tighten the screw on the lower front of the cover.
Adding New Modules
10-10
2-16).
"Connecting Lines and