Clearing A Backup-Failure Alarm; 012E Module Power Management - Avaya PARTNER Advanced Communications System Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use

Clearing a Backup-Failure Alarm

If you use Backup Programming—Automatic (#123) and the automatic backup fails, a Backup-
Failure Alarm message appears (instead of the default day/date/time message) on the top line of
the telephone display at idle extensions 10 and 11.
After correcting the problem that caused the failure, you can clear the Backup-Failure Alarm by
following these steps:
f00ss#123
1. Press
The current setting appears.
3
2. Press to choose Option 3, "Backup Alarm Cleared."
You cannot use
3. Exit programming mode.
Using Option 3 to clear a Backup-Failure Alarm does not change the setting for
Backup Programming—Automatic (#123). It remains either Active or Not Active.

012E Module Power Management

The power supply used in the 012E module is adequate to power the 12 ETR ports under normal
conditions. However, if too many large PARTNER telephones (such as the PARTNER-34D) are
off-hook with speakerphone volume set to high levels, the power supply could be overloaded.
Power management of the 012E module eliminates the power supply overload.
When a power threshold is exceeded, all telephones connected to the 012E module will appear as
follows:
LED display dims to a minimal level
Speakerphone volume is decreased
To clear this condition, place one of the telephones connected to the 012E module on-hook. The
LED display and speakerphone volume on all telephones return to normal. If this power
management event occurs frequently, you should consider moving some telephones to available
ports on other modules.

Clearing a Backup-Failure Alarm

11-4
D d
or in this procedure to choose Option 3.
1 1
.
1 1