AT&T MERLIN LEGEND Release 3.1 Installation Manual page 241

Integrated Solution III
For AUDIX Voice Power, you cannot use an 008 OPT module.
If IS III includes AUDIX Voice Power (or Fax Attendant) when users receive
voice mail (or fax mail) messages, the Message LEDs on their telephones light
(as long as a mailbox or fax mailbox has been assigned to each of those
telephones).
The system may need more touch-tone receivers if:
Single-line telephone users do not get dial tone.
AUDIX Voice Power fails to transfer calls.
Calls fail to ring or go to coverage prematurely.
Message-waiting lights fail to light.
CAS IS III uses the call information provided by the system's built-in SMDR
feature to process calls.
SPM IS III reports can be printed out or can be written to a disk (hard or
floppy).
SPM IS III reports should not be printed while the system is handling more
than 100 calls per hour.
Only the CAS IS III and the SPM IS III applications can be connected to a
system operating in Behind Switch mode.
Hardware Requirements
The Master Controller II+ (Desktop) and the Master Controller III (Tower) are
the PC platforms for IS III. The Master Controller II+ is a desktop 20-MHz, 386-
SX PC with three available AT bus slots (with the tape drive installed). It has 8
MB of RAM memory, either a 100-MB or a 200-MB hard disk drive, 3.5-inch
floppy drive, and a 125-MB streaming tape drive.
Installing Applications
8–15