Changing System Size; Planning Forms - AT&T Merlin II Installation And Maintenance Manual

CHANGING SYSTEM
SIZE
If you change the system size designation from small to
large, or vice versa, the system reverts to the default
setting. See "Default Setings" on pg 3-15. In addition,
the line assignments will change on all attendant consoles.
Be sure to record the changes on the appropriate
NOTE:

planning forms.

With a Display Console
1
Enter administration mode by sliding the T/P switch to
P.
2 Press Conference twice.
The administration menu appears.
3
Press
[System], [Size]
Press or
[Small]
4
You see the message, "System is Re-starting..." The system
renumbers, then the administration menu appears on the display.
5 Continue administration or leave administration mode
by sliding the T/P switch to the center position.
With a BIS-34D Console
1
Enter administration mode by sliding the T/P switch to
P.
2 Press Conference twice.
Lights flash next to Adm Tel, Adm Pool Message and Speaker.
3
Press Message.
Light goes on steady next to Message. Flashing lights go off.
4 Dial #201.
Two beeps sound.
5 Dial number to designate system size:
=
0 small
1 = large
Lights flash next to Adm Tel, Adm Pool, Message and Speaker.
.
for the system size wanted.
[Large]
.
Administering a Changed System 3-65