To Enter Administration Mode; To Leave Administration Mode; Summary Of Administration Process - AT&T Merlin II Installation And Maintenance Manual

TO ENTER
ADMINISTRATION
MODE
TO LEAVE
ADMINISTRATION
MODE
SUMMARY OF
ADMINISTRATION
PROCESS
3-18 Before Administering a System
Follow these steps to enter the administration mode:
1 Slide the T/P switch on the left side of the console to
P.
Press Conference twice.
2
On the DisplayConsole, the administration menu appears. On the
BIS-34D Console, lights start flashing next to Adm Pool, Adm
Tel, Message, and Speaker.
To leave administration mode, slide the T/P switch to the
center position.
Following is a Iist of the procedures that make up the
administration process. The procedures are listed in the
order in which they are performed.
Set system operating conditions
> Set system size
> Set system type
> Designate attendant positions
Perform flexible numbering (FM2 and R3 only)
Administer lines
> Assign lines to pools
> Specify toll type
> Specify Touch-Tone or rotary signaling on lines
Administer stations
> Assign lines and line pools to stations
> ldentify analog voice terminal type
Identify jacks for voice announcement to busy
>
voice terminal feature