Adding A Voice Terminal - AT&T Merlin II Installation And Maintenance Manual

ADDING A VOICE
TERMINAL
4 If all line jacks in the control unit are full, you can add
any combination of line modules m the system so long
as the sum total of outside lines does not exceed 56.
Contact an equipment supplier to order additional line
modules.
Add each new line module, if necessary, according to
the instructions in the procedure, "Module Installation"
on page 2-62.
5 Readminister the system so that it recognizes the
newly added lines. Refer the information under
"Administering Lines" on page 3-32.
NOTE: Depending on the system configuration, you
may want to assign the new line to an
appropriate pool or assign the line to a new
line button on one or more voice terminals.
See the appropriate entry in Section
3, "Administration" for instructions on
assigning lines to pools or voice terminals.
6 Record the new information on the outside-line
numbers label and on Form 1A, System Form–
Incoming Lines for Release 3 or on the Master
Planning Form (Line Jack section) for Feature
Modules 1 and 2.
The MERLIN II System can have up to 120 station jacks,
which accommodate up to 120 voice terminals. Eight of
these must be analog jacks; 112 can be a combination of
analog, basic, or digital jacks. The Simultaneous Voice
and Data feature and the Voice Announcement to Busy
Voice Terminal feature reduce the total number of voice
Modifying the System 2-113