AT&T Merlin II Installation And Maintenance Manual page 107

6 Insert and punch down (connect the wires of the
spooled cable into the cutdown section of the adapter
next the label for wiring run 1 in the jack field (the
to
top jack in the box labeled 1-6). If necessary, trim
the ends of the wires with a pair of scissors or diagonal
pliers.
7 Run the other end of the cable to the voice terminal
location where wiring run number 1 ends. Use cable
clips and/or staples to attach the cable along walls,
baseboards, and moldings.
Run the rest of the cables consecutively from the
8
connections in the jack field to the corresponding
voice terminal locations.
Follow this
procedure to terminate wiring runs in modular
wall jacks.
1 At the voice terminal location for wiring run number 1,
mark the place on the wall where you want to put the
modular wal1 jack.
2 Trim the excess cable, leaving enough so that about 4
inches extend beyond the outline of the modular jack
you drew on the wall.
3 Loosen the screw that holds the cover of the wall jack
in place, remove the cover, and set the cover and screw
aside.
4 Using the cable termination tool, remove about 2
inches of the cable's jacket. This exposes the color-
coded twisted pairs of wires inside the jacket.
5 Thread the cable from the bottom of the jack up
through the center until the exposed wires and 1/4 inch
of the cable's jacket come through next to the center
post on the jack.
Wiring the System 2-39