Get A Printout Of The Existing System - AT&T Merlin II Installation And Maintenance Manual

Hide thumbs Also See for Merlin II:
Table of Contents

Advertisement

GET A PRINTOUT OF
THE EXISTING
SYSTEM
2-132 Upgrading an Existing System
adding more stations, and if there is a jack field for
• If
them, you may need to enlarge that jack field. If no
jack field exits, one may have to be built, especially if
there are to be more than 30 stations, since a jack field
would be the preferred method of connecting that
many stations to the control unit. See "Jack Field
Wiring" on page 2-33 for instructions that will enable
you to enlarge or build the jack field.
Recall that the maximum number of stations is the
following for the different MERLIN II systems:
> Feature Module 1 =72
> Feature Module 2 = 88 (72 responding stations)
> Release 3 = 120
Before you change the existing system
printout of the existing system settings
later restore any voice terminal programming and system
administration that will still apply to the new system. To
get a printout from the administration menu, foIlow these
steps:
With a Display Console
Enter administration mode by sliding the T/P switch to
1
P.
Press Conference twice.
2
The administration menu appears.
3
Press
[More], [More], [Print], [All].
Wait until printing is complete before leaving
administration mode. Don't remove the printout
after you've left administration mode or printing
alignments will be affected.
to upgrade it, get a
so that you can
until
page

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Merlin II and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents