Labeling Each Voice Terminal - AT&T Merlin II Installation And Maintenance Manual

Verify Intercom
Number
LABELING EACH
VOICE TERMINAL
2-96 Connecting the Voice Terminals
5
Lift the handset.
Red and green lights are on and a dial tone is present.
6
Touch one or more dial pad buttons.
The dial tone stops.
7
Hang up the handset.
The green light goes out.
If the voice terminal does not respond as described, make
a note of the problem and refer to Section 4,
"Troubleshooting."
Verify the voice terminal's intercom number as follows:
1 Using a working voice terminal, touch Intercom (fifth
button down in the leftmost column).
2 Lift the handset or press Speakerphone
3 Dial the intercom number you want to verify.
If the voice terminal with the intercom number you dialed rings,
you have verified the intercom number.
If you dial an intercom number that is not
NOTE:
assigned or in use, you will hear a busy
signal.
As you test the voice terminals, label each one with its
intercom number as follows:
1
Find the intercom number labels that came with the
voice terminal and fill in an intercom number label for
each voice terminal.
2
Pry the plastic number card retainer from its position
below the handset rest.
3
Lay the intercom number label in the recess, and
replace the plastic retainer.