Connect Each Voice Terminal To The System - AT&T MERLIN 820 Installation Manual

CONNECT EACH VOICE TERMINAL TO THE SYSTEM

1
Place the voice terminal in its designated location.
2 Plug the voice terminal into the system in one of the following ways:
Do This
a direct connection
from the voice terminal only a single modular
to the control unit
a jack field connection
to the control unit
A red light comes on next to a button when you plug in the
voice terminal.
22
If Then
the connection requires Go on to step 3. You
have already con-
nected the voice ter-
voice terminal cord
minal to the system
in step 3 of "Prepare
the Voice Ter-
minals," page 22.
the connection requires Plug the loose end
one or more modular of the modular voice
extension cords terminal cord into
the jack on the ex-
tension cord that ter-
minates the wiring
run from the control
unit location. Then
go on to step 3.
Plug the loose end
of the modular voice
terminal cord into
the wall jack at the
voice terminal loca-
tion. Then go on to
step 3.
Jack field
2
Building
Modular wall jack
wiring
Modular
extension
cord to the
2
Modular voice
control unit
terminal cord
1