Connect Each Voice Terminal To The System - AT&T MERLIN 410 Installation Manual

CONNECT EACH VOICE TERMINAL TO THE SYSTEM

1
Place the voice terminal in its designated location.
2 Plug the voice terminal into the system in one of the following ways:
If You Have
a direct connection
from the voice ter-
minal to the control
unit
a jack field connec-
tion to the control unit
A red light comes on next to a button when you plug in the voice terminal.
16
And Do This
the connection re- Go on to step 3. You
have already con-
quires only a single
modular voice ter- nected the voice ter-
minal cord minal to the system in
step 3 of "Prepare
the Voice Terminals,"
page 15.
the connection re- Plug the loose end of
quires one or more the modular voice ter-
modular extension minal cord into the
cords jack on the extension
cord that terminates
the wiring run from
the control unit loca-
tion. Then go on to
step 3.
Plug the loose end of
the modular voice ter-
minal cord into the
wall jack at the voice
terminal location.
Then go on to step 3.
2
Jack field connection
Direct connection
to control unit
1