Upgrading CMS to the High Availability Option
Setting Up the Alarm Originator
Setting Up the Alarm Originator
Setting Up the NTS
Configuring the
NTS
8. Enter y. The system automatically reboots and the remote console
port comes up as a regular dial-in port with the login: prompt
displayed.
As the system reboots, the shutting-down messages appears on the
remote console. When the system starts to come back up, the
system boot diagnostics should appear on the local console. After
the system reboots, a login prompt should appear on the local
console.
9. Log into the local console as root .
The console has been redirected from the remote console to the
local console.
For information on setting up the alarm origination manager on the HA
servers, see "CentreVu CMS R3V8 Alarm Origination Manager (585-215-
884).
For information about setting up the NTS, see "Setting up the NTS", in
Chapter 2 of "CentreVu Call Management System R3V8 Software
Installation and Setup" (585-210-941).
This procedure is performed on NTS devices when:
• the NTS is newly installed, or
3
• the NTS requires reconfiguration during a manual HA server switch-
over after the HA server to which the NTS was initially connected
has experienced a failure event
1. Connect a dumb terminal to the Console Port on the rear of the NTS
using the console cable and adapter that came with the NTS. On
the 8- and 16-port NTSs, the Console Port is port #1.
You will need the following for the 8- and 16-port units:
• Console Cable
• Adapter - comcode 407361823
• Null Modem - comcode 407122043.
CentreVu CMS R3V8 High Availability
Connectivity, Upgrade and Administration
3-59
3
C
Need help?
Do you have a question about the CentreVu Release 3 Version 8 High Availability Connectivity, Upgrade and Administration and is the answer not in the manual?