Lucent Technologies CentreVu Release 3 Version 8 High Availability Connectivity, Upgrade and Administration User Manual page 111

Administering the Switch for CMS High Availability Systems
Administering the Definity Switch
Field
Route Number
Destination Node
Gateway
C-LAN Board
Metric
Route Type
CentreVu CMS R3V8 High Availability
Connectivity, Upgrade and Administration
Definition
If the link between the switch and the CMS
computer is a dedicated link through a hub,
you only need to assign one IP route. If you
are going through a router, you must set up
IP route 1 from the switch to the router, and
then set up IP route 2 from the switch to the
CMS computer. The example above shows a
simple IP route.
This field represents the node name of the
destination for this route. You would typically
enter the node name for the CMS computer
or a router, depending on your configuration.
Enter the node name of the gateway by
which the destination node is reached for this
route. This is either the local C-LAN port or
the first intermediate node between the
C-LAN port and the final destination. For
example, if there were one or more routers
between the C-LAN port and the final
destination node (the CMS computer), the
gateway would be the node name of the first
router.
Enter the equipment location of the CLAN
circuit pack that provides this route.
Specifies the complexity of this IP route.
Enter 0 if there are no intermediate nodes
between the switch C-LAN port and the
ethernet port on the CMS computer. A metric
value of 1 is used only on a switch that has
more than one C-LAN circuit pack installed.
See DEFINITY ECS Administration for
Network Connectivity for more information
about using this field.
Specifies whether the route is host or
network (default). Use a Host route to get to
a specific IP address. Use a Network route to
get to a subnet.
4-17