Chapter 9 Oam; Cfm - D-Link DWS-3160-24TC Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
Chapter 9

CFM

Ethernet OAM
Cable Diagnostics
CFM
CFM Settings
This window is used to configure the CFM parameters.
To view this window, click OAM > CFM > CFM Settings, as shown below:
The fields that can be configured are described below:
Parameter
CFM State
All MPs Reply LTRs
MD
MD Index
Level
MIP
SenderID TLV
Click the Apply button to accept the changes made for each individual section.
OAM
Figure 13-1 CFM Settings Window
Description
Here the user can enable or disable the CFM feature.
Here the user can enable or disable all MPs to reply LTRs.
Here the user can enter the maintenance domain name.
Specifies the maintenance domain index used.
Here the user can select the maintenance domain level.
This is the control creations of MIPs.
None – Don't create MIPs. This is the default value.
Auto – MIPs can always be created on any ports in this MD, if that port is not
configured with a MEP of this MD. For the intermediate switch in a MA, the setting must
be auto in order for the MIPs to be created on this device.
Explicit – MIPs can be created on any ports in this MD, only if the next existent lower
level has a MEP configured on that port, and that port is not configured with a MEP of
this MD.
This is the control transmission of the SenderID TLV.
None – Don't transmit sender ID TLV. This is the default value.
Chassis – Transmit sender ID TLV with chassis ID information.
Manage – Transmit sender ID TLV with managed address information.
Chassis Manage – Transmit sender ID TLV with chassis ID information and manage
address information.
276