Compound Authentication Guest Vlan Settings - D-Link DWS-3160-24TC Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
Authorized Mode
CP Configuration
VID List
State
Click the Apply button to accept the changes made for each individual section.
NOTE: Per VLAN authentication is only supported by Captive Portal. If Authentication Method is not
None, the port will work as authentication VLAN disabled.

Compound Authentication Guest VLAN Settings

Users can assign ports to or remove ports from a guest VLAN.
To view this window, click Security > Compound Authentication > Compound Authentication Guest VLAN
Settings as shown below:
The fields that can be configured are described below:
Parameter
VLAN Name
VID (1-4094)
Port List
Action
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Once properly configured, the Guest VLAN and associated ports will be listed in the lower part of the window.
on a port at the same time. In Any (MAC, 802.1X, or CP) mode, whether an
individual security module is active on a port depends on its system state.
802.1X+IMPB - 802.1X will be verified first, and then IMPB will be verified.
Both authentication methods need to be passed.
MAC+IMPB - MAC will be verified first, and then IMPB will be verified. Both
authentication methods need to be passed.
IMPB+CP – IMPB will be verified first, and then CP will be verified. Both
authentication methods need to be passed.
Toggle between Host-based and Port-based. When Port-based is selected, if
one of the attached hosts passes the authentication, all hosts on the same
port will be granted access to the network. If the user fails the authorization,
this port will keep trying the next authentication method. When Host-based is
selected, users are authenticated individually.
Select a captive portal configuration ID between 1 and 10.
Enter a list of VLAN ID.
Use the drop-down menu to assign or remove the specified VID list as
authentication VLAN(s).
Figure 11-38 Compound Authentication Guest VLAN Settings window
Description
Click the button and assign a VLAN as a Guest VLAN. The VLAN must be an existing
static VLAN.
Click the button and assign a VLAN ID for a Guest VLAN. The VLAN must be an
existing static VLAN before this VID can be configured.
The list of ports to be configured. Alternatively, tick the All Ports check box to set
every port at once.
Use the drop-down menu to choose the desired operation: Create VLAN, Add Ports,
or Delete Ports.
220