Table of Contents
Advertisement
9. Service Mode
The lamp menu will be displayed.
LAMP
Constant Light output [OFF]
Using [RS port]
Mode [NORMAL]
Serial number :
R101111
Article number :
R9840xxx
Run time :
10 hours
Remaining run time :
hours
Number of strikes :
Z_AXIS : 100
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 9-27
How to switch the constant light output?
1. Push the cursor key ↑ or ↓ to highlight Constant Light Output.menu 9-27
2. Press ENTER to toggle between [OFF], [SLAVE] and [MASTER].
[OFF]
fixed power, no power adaptation.
[SLAVE]
follows the master projector to adjust the CLO. When stand alone and the light output should be adjusted,
put on slave.
[MAS-
master projector to control the CLO in a chain of projectors.
TER]
Linked port
1. Push the cursor key ↑ or ↓ to highlight Using.menu 9-27
2. Press ENTER to toggle between [RS port] or [Comm port].
[RS port]
[Comm port]
Mode switching
1. Push the cursor key ↑ or ↓ to highlight Mode.menu 9-27
2. Press ENTER to toggle between [NORMAL] and [ECONOMIC].
normal
economic
9.10 Dimming
What is possible
The lamp can be dimmed in small steps only when the lamp is used in Normal mode. The dimming can be done between normal
mode and economic mode.
How to dim
1. Push the cursor key ↑ or ↓ to highlight Dimming.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-28
122
490
10
RS port is used to make a linked connection
Comm port is used to make a linked connection
normal light output
reduced light output (+ less noise)
R5976654 SLM R12+ 27/01/2005
Advertisement
Table of Contents
