Table of Contents
Advertisement
9. Service Mode
The following items will be displayed:
•
Type of projector: SLM R12+
•
Software version
•
Network module: yes
•
Proj. address: To change the address of the projector, see "Change Projector Address", page 114
Installation:
-
front/ceiling
-
front/table
-
rear/ceiling
-
rear/table
•
Baud rate: transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be
the same as the baud rate of the connected computer. When there is a difference, consult 'Change Baudrate PC' in this chapter.
•
Projector Run Time: gives the total run time since the first start up. All projectors leave the factory with a run time of approxi-
mately 24 hours.
•
Projector Serial number: indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
Start Up
1. Push the cursor key ↑ or ↓ to highlight Identification.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-4
2. Press ENTER to display the Identification screen.
SLM R12+
Proj.
address:
001
Soft.
version:
3.0
Config:
front/ceiling
Bautrate PC: 9600
Network module:
yes
Text:
on
Serial No:1010200
Run time:
100 h
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 9-5
9.4 Password
Overview
•
Change Password
•
Access Control List
9.4.1
Change Password
How to enable or disable the password function ?
This item is password protected when the password strap is installed.
The password function is enabled when the password strap, second switch of S2 on the controller module is installed. Consult an
authorized Barco service technician to change the strap position.
About password types.
3 different password levels are built in, in the projector software.
110
R5976654 SLM R12+ 27/01/2005
Advertisement
Table of Contents
