Table of Contents
Advertisement
Master Projector
Comm port
Comm 800 splitter
To slave 1
To slave 3
To slave 2
Image 9-8
Principal diagram: Linked via Comm port
For more information about the use of the Comm 800 splitter, consult the Comm 800 splitter documentation (R5976819).
Which information is available
serial number
type
run time
remaining run time
number of strikes
Z-AXIS
How to display the lamp menu
1. Push the cursor key ↑ or ↓ to highlight Lamp.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-26
2. Press ENTER to select.
R5976654 SLM R12+ 27/01/2005
To next Comm 800 splitter
"To Switcher"
Comm 800 splitter
To slave 4
To slave 6
To slave 5
unique serial number of the lamp
lamp type
total time the lamp is used in this or other projectors.
time left before the lamp must be replaced Using the lamp longer than the maximum run time may
damage the projector.
Total times the lamp is started up.
indication to adjust the Z-AXIS of the lamp (see Re-adjustment of the lamp position in chapter
Installation Guidelines).
To slave 7 or to
next Comm 800 splitter
"To Switcher"
9. Service Mode
121
Advertisement
Table of Contents
