Table of Contents
Advertisement
4. Connections
slot 1
slot 2
slot 3
slot 4
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module has to be
connected to slot 1 of the projector. To switch the projector in the 5-cable mode see "Fixed slot (slot 1 & 2)", page 37.
4.5.3
Input module insertion
How to insert an input module?
To insert a module in one of the free slots, handle as follow :
1. Power down the projector and disconnect the power cord from the wall outlet.
2. Remove the dummy plate covering the chosen input slot by turning out both screws.
3. Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
4. Press on both handles of the input module until the module plug seats in the connector of the projector.
Two way
hardwired
remote
CTRL 3
On
R
High Bandwidth 5 CABLE INPUT
R
High Bandwidth 5 CABLE INPUT
Image 4-4
5. Secure the input module by tightening both retaining screws.
6. Reconnect the power cord to the wall outlet and switch on the projector.
How to select the new installed module?
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
36
RGB/Component
Video
not used
not used
Diagnostic Code
Green Operation
Red Stand-by
Hardwired
remote
CTRL 2
Sync OK
IR
Hardwired
remote
RS232/422 IN
RS232/422 OUT
CTRL 1
OUT
IN
On
SDI DIGITAL INPUT
G
B
H/C
V
DVI INPUT
H/C
V
G
B
DVI INPUT
IR-Receiver
COMM PORT
10/(100)BASE-T
IN
OUT
HD SDI DIGITAL MODULE
DVI OUTPUT
R5976654 SLM R12+ 27/01/2005
Advertisement
Table of Contents
