Cleaning, maintenance
44
Cleaning, Maintenance
Cleaning the screen and the sewing computer
Wipe with a damp cloth.
Feed-dog area
Clean the sewing computer after every use - remove any lint from under the
stitch plate and in the hook area.
power switch to «0» (off)
█
pull out plug from electrical outlet
█
remove presser foot and needle
█
open the free arm cover
█
press the stitch plate down at the back right corner, lift and remove
█
clean the area with the lint brush
█
replace the stitch plate
█
Cleaning the hook
power switch to «0» (off)
█
pull out plug from electrical outlet
█
remove the bobbin case
█
push the release lever to the left
█
let down the locking lever and the black hook race cover
█
remove the hook
█
clean the hook race with a cloth or brush, never use a sharp instrument
█
replace the hook, turning the handwheel if necessary until the hook driver is
█
on the left
close the hook race cover and secure with the locking lever, the locking pin
█
must engage
check by turning the handwheel
█
insert the bobbin case
█
Lubricating
power switch to «0» (off)
█
pull out plug from electrical outlet
█
squeeze 1 or 2 drops of oil into the hook race
█
run the sewing computer for a short time without thread to prevent oil
█
soiling your work
Disconnect plug from the socket before cleaning or lubricating!
Never use alcohol, petrol, white spirit or any type of solvent to
clean the sewing computer!
033301.70.04_1007_B330_B350_B380_EN