Cleaning, maintenance
Cleaning the screen and the sewing computer
Wipe with a damp cloth.
Feed-dog area
Clean the sewing computer after every use - remove any lint from under the
stitch plate and in the hook area.
⦁
power switch to «0» (off)
⦁
pull out plug from electrical outlet
⦁
remove presser foot and needle
⦁
open the free arm cover
⦁
press the stitch plate down at the back right corner, lift and remove
⦁
clean the area with the lint brush
⦁
replace the stitch plate
Cleaning the hook
⦁
power switch to «0» (off)
⦁
pull out plug from electrical outlet
⦁
remove the bobbin case
⦁
push the release lever to the left
⦁
let down the locking lever and the black hook race cover
⦁
remove the hook
⦁
clean the hook race with a cloth or brush, never use a sharp instrument
⦁
replace the hook, turning the handwheel if necessary until the hook driver
is on the left
⦁
close the hook race cover and secure with the locking lever, the locking pin
must engage
⦁
check by turning the handwheel
⦁
insert the bobbin case
Lubricating
⦁
power switch to «0» (off)
⦁
pull out plug from electrical outlet
⦁
squeeze 1 or 2 drops of oil into the hook race
⦁
run the sewing computer for a short time without thread to prevent oil
soiling your work
WARNING!
Disconnect plug from the socket before cleaning or lubricating!
WARNING!
Never use alcohol, petrol, white spirit or any type of solvent to
clean the sewing computer!
Cleaning, maintenance
Cleaning, maintenance
43