Amanda @SOHO Version 3.xx Switching Manual page 76

68
Program and Its Purpose
Mailbox ID Code: Make sure that all the jacks/ex-
tension have the value "Not Stored".
Call Forwarding: Provide the code needed to leave
and get messages.
Operator/Manager: Enter the jack number that the
operator is assigned to as OPE-1. If you have a back-
up operator, enter the jack number for that person as
OPE-2.
You can also use this program to set a jack number
for the manager. This provides an additional jack
from which programming can be done.
Telephone Switching Systems for Amanda@SOHO
What You Enter
NEXT
(Press 6 if not already
there.)
NEXT
(Press 7 if not already
there.)
NEXT
(Press 8 if not already
there.)
609
NEXT
NEXT
If not "Not Stored" i.e.
blank, press SHIFT to
toggle to
If not "Not Stored" i.e.
blank, press CLR
Repeat last three steps
for all jacks/exten-
sions.
114
NEXT
#6H
(to get the H, press the
FLASH button)
NEXT
*H#
006
NEXT
What You See on Display
FWD VM RBT:6
SKP+ CLR NEXT
FWD VM BT:7
SKP+ CLR NEXT
FWD EXT RBT:6
SKP+ CLR NEXT
Mailbox ID Code
SKP+ CLR NEXT
Jack NO?->
SKP+ CLR NEXT
#01-1:Not Stored
-> SEL NEXT
#01-1:Not Stored
-> CLR NEXT
#01-1:
-> CLR NEXT
VM Command Set
SKP+ CLR NEXT
LV-MSG:#6H
GETMSG:*H#
-> SEL NEXT
Operator/Manager
SKP+ CLR NEXT
OPE-1:Jack01
-> SEL NEXT