Programming The Iwatsu Adix; Entering And Exiting Programming Mode; Initializing The System; Using The Telephone Keys And Buttons - Amanda @SOHO Version 3.xx Switching Manual

Chapter 5:

Programming the Iwatsu Adix

Entering and Exiting Programming Mode

Initializing the System

Using the Telephone Keys and Buttons

The Iwatsu ADIX can either use a laptop or terminal with Iwatsu-provided software,
connected to the RJ45 port labeled "PC" on the front of the EDVIF circuit card, or can use
a display telephone plugged into Port 1 (which defaults to extension 201).
To enter programming mode from the telephone:
1. Place programming template over keypad and buttons (or use the diagram in this
chapter).
2. Press Feature # 1 2 3 4 9 7 which places this telephone in programming mode.
The display reads:
ENTER CLASS X0#1
ADIX -M-KT
To exit programming mode from the telephone:
1. Lift the telephone receiver and replace it.
2. Press the red reset button on the small red reset button (located on the CPU card
inside the computer).
3. Wait for the display to show the date again. This takes a few minutes.
IF the telephone system is not initialized, then you must first create Class 1 level telephone
assignments which assign a physical port to a type of telephone and the logical port
address. Once all of the telephones have been programmed, press the small red reset
button (located on the CPU card) so that all new settings take place.
IF the system is already initialized, ignore this section.
You use the telephone keys and buttons as you program. Use the following diagram to
identify the keys and buttons if you don't have the template on.