Fuser Exit Sensor Assembly (PL 5.1.3)
1.
Remove the Fuser Exit Roller (see pg. 6-182).
2.
Remove the Print Unit Chassis (see pg. 6-156).
3.
From the Engine Controller Board, remove the connector to the Fuser Exit Sensor
Assembly (PARTTEMP).
4.
Lift and remove the Duplex Exit Gate.
5.
Remove 1 B screw securing the Fuser Exit Sensor Assembly.
6.
Guide the sensor wiring harness through the chassis as you remove the assembly.
FRU Disassembly
S7300-76
6-183