Tool-Less Rail Rack Mount Servicing; Installing And Removing The Front Bezel; Figure 20. Front View With Bezel Supporting The Standard Control Panel - Intel SR1600UR - Server System - 0 MB RAM Service Manual

8. Align the inner rails (attached to the server chassis) with the outer rail assemblies
(attached to the rack).
9. Engage the matching rails and slide the server chassis into the rack until the two
safety stops lock into position.
10. Depress the two safety locks (one on each side).
11. Slide the server chassis all the way into the rack.
12. Use the rack screws (#10-32 x 3/4) to secure the chassis and rack handles into the
rack.

Tool-less Rail Rack Mount Servicing

1. To service the system, pull the system out from the rack.
2. Disconnect the power cable(s) and proceed with servicing the system.
3. When the servicing is completed, re-connect the power cable(s).
4. Pull up on the green tabs on each rail and slide the system back into the rack.
Note: Beware of cables when re-installing the system into the rack so that the cables do not get
pulled or interfered with.

Installing and Removing the Front Bezel

The front bezels are available as optional accessories for the Intel
SR1600UR. The following front bezel options are available:
•
Bezel for use with the Standard Control Panel (Product Order Code:
ADWBEZBLACK)
•
Bezel for use with the Intel
ADWLCDBEZEL)
To identify your bezel, see the following figures. Note the orientation in the figures below
- the control panel is at the right. If you are installing a bezel on your server system, make
sure you position it as shown.

Figure 20. Front View with Bezel supporting the Standard Control Panel

36
®
Local Control Panel (Product Order Code:
®
Intel Server System SR1600UR Service Guide
®
Server System
TP02197