HP ProLiant BL620c - G7 Server Troubleshooting Manual page 57

Modem does not connect to another modem
Action:
Be sure a dial tone exists.
1.
Be sure the line is not in use at another extension before using it.
2.
Be sure you are dialing the correct telephone number.
3.
Be sure the modem on the other end is working.
4.
Modem disconnects while online
Action:
Be sure no loose connections (on page 18) exist.
1.
Be sure no line interference exists. Retry the connection by dialing the number several times. If
2.
conditions remain poor, contact the telephone company to have the line tested.
Be sure an incoming call is not breaking the connection due to call waiting. Disable call waiting,
3.
and then reestablish the connection.
AT command initialization string is not working
Action: Use the most basic string possible to perform the task. The default initialization string is
AT&F&C1&D2&K3.
Connection errors are occurring
Action:
Check the maximum baud rate for the modem to which you are connecting, and then change the
1.
baud rate to match.
If the line you are accessing requires error control to be turned off, do so using the AT command
2.
AT&Q6%C0.
Be sure no line interference exists. Retry the connection by dialing the number several times. If
3.
conditions remain poor, contact the telephone company to have the line tested.
Be sure the modem is current and compliant with CCITT and Bell standards. Replace with a
4.
supported modem if needed.
You are unable to connect to an online subscription service
Action:
If the line you are accessing requires error control to be turned off, do so using the AT command
1.
AT&Q6%C0.
If the ISP you are accessing requires access at a decreased baud rate, reconfigure the
2.
communications software to correct the connection baud rate to match the ISP.
If this does not work, force a slower baud rate (14400 baud) with the AT command
3.
AT&Q6N0S37=11.
Hardware problems 57