S875WP1-E TPS
Table 49. Primary/Secondary Master/Slave Submenus
Feature
Options
Drive Installed
No options
• User
Type
• Auto (default)
Maximum Capacity
No options
• Disabled
LBA / Large Mode
• Auto (default)
• Disabled
Block Mode
• Auto (default)
• Auto (default)
PIO Mode
• 0
• 1
• 2
• 3
• 4
• Auto (default)
DMA Mode
• SWDMA 0, 1, or 2
• MWDMA 0, 1, or 2
• UDMA 0, 1, 2, 3, 4, 5
Feature
Options
• Auto (default)
S.M.A.R.T
• Disabled
• Enabled
(Note)
Cable Detected
No options
Note:
These configuration options appear only if an IDE device is installed.
Revision 4.0
Description
Displays the type of drive installed.
Specifies the drive configuration.
User allows capabilities to be changed.
Auto fills-in capabilities from the device.
Displays the capacity of the drive. (SATA only)
This option can be changed only if User is selected as the type.
This option can be changed only if User is selected as the type.
This option can be changed only if User is selected as the type.
This option can be changed only if User is selected as the type.
SWDMA = Single Word DMA
MWDMA = Multi Word DMA
UDMA = Ultra DMA
Description
This option can be changed only if User is selected as the type.
If Auto is selected, this option is not displayed.
Enables or disables Self-monitoring, Analysis, and Reporting
Technology.
Displays the type of cable connected to the IDE interface: 40-
conductor or 80-conductor
(for ATA-66/100 devices).
BIOS Setup Program
69