Attaching The Fixed Rack Mount Kit Rails To The Switch - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

Installing the SAN Switch 2/8
2. Repeat steps 1a through 1d to attach right front bracket (Item 8) to the right
1
Left front bracket
1
Left rear bracket
2
6-32 x 5/16-inch pan head Phillips screws
3
Right rear bracket
4
Figure 6: Attaching the Fixed Rack Mount Kit rails to the switch
3. Position the switch in the rack as shown in Figure 6, providing temporary
4. To secure the front brackets to the rack's front rails, attach the right front
5. Repeat step 4 to attach the left front brackets (Item 1) to the left front rack rail.
6. Tighten all screws and torque to 25-inch pounds.
34
side of the switch, see
support under the switch (use clamps if necessary).
bracket (Item 8) to the right front rack rail using two 10-32 x 5/8 inch screws
(Item 5) and two retainer nuts (Item 6).
Figure 6.
2
3
7
8
10-32 x 5/8-inch pan head Phillips screws
5
Retainer nuts
6
8-32 x 5/16-inch pan head Phillips screws
7
Right front bracket
8
SAN Switch 2/8 Version 3.1.x Installation Guide
5
4
6
SHR-2501A