Connecting The Serial Cable - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

Installing the SAN Switch 2/8
2. Connect the Serial cable to the SAN Switch 2/8 Serial port. See
Figure 23: Connecting the Serial cable
3. Connect the other end of the Serial cable to an RS-232 Serial port on the
4. Verify that the switch power is on and POST is completed. See the
5. Power on the workstation and establish a connection to the switch using a
Note:
application, consult the specific application's documentation.
6. Using HyperTerminal, configure the port settings as follows:
58
workstation. If no RS-232 Serial port is available on the workstation, the
adapter on the end of the Serial cable can be removed to use the RJ-45
connector to create a Serial connection.
Self-Test" section, on page 56 in this chapter.
terminal emulator application (such as HyperTerminal).
Step 6 shows instructions specific to HyperTerminal. If using a different
Bits per second: 9600
Databits: 8
Parity: None
Stop bits: 1
Flow control: None
SHR-2497B
SAN Switch 2/8 Version 3.1.x Installation Guide
Figure 23.
"Power On