Violation Timer Errors; Full Fabric License Install Prompt In Web Tools - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

Installing the SAN Switch 2/8
If the timer expires while trying to access Web Tools (for example, Zone Admin,
Switch Admin, or Switch View), an HTML file similar to license.htm appears,
stating that Web Tools is disabled. In addition, a prompt displays (see
allowing you to install the optional Fabric license. After the Full Fabric license is
installed, all Web Tools functionality resumes.
Figure 4: Full Fabric license install prompt in Web Tools

Violation Timer Errors

The violation timer begins decrementing when the four switch limitation is
exceeded. The timer is cumulative. Resetting the power cycle will not reset the
timer.
If the switch is moved to a fabric with less than five switches, the error condition
is cleared; however, the violation timer stops counting down. If the switch is
moved to a fabric with more than four switches, the violation timer continues
from where it left off. When the accumulative violation timer reaches 45 days (not
configurable), Web Tools for that switch is disabled. A message similar to
Figure 4
Note:
license installed, the four switch limitation warning messages display. If the IV_FABRIC
license is not installed, Quiet Mode works as described in the
OS Version 3.1.x/4.1.x Reference Guide
26
displays in a telnet session or error log.
When Quiet Mode is enabled on a SAN Switch 2/8 EL with a IV_FABRIC
HP StorageWorks Fabric
.
SAN Switch 2/8 Version 3.1.x Installation Guide
Figure 4)