Installing The Switch In A Rack Using The San Switch Rack Mount Kit - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32
3. Connect the power cables to the SAN Switch 2/32 power connectors and to a
4. Turn on the power to the switch (flip the AC switch to 1). The switch
Installing the Switch in a Rack Using the SAN Switch Rack
Mount Kit
This section provides instructions for installing the switch in an HP System/e
cabinet, or in an HP 10000 series cabinet using the HP StorageWorks SAN Switch
Rack Mount Kit supplied with your switch. The Rack Mount Kit installation
requires one technician to install a SAN Switch.
The following items are required to install the switch in a cabinet:
The SAN Switch Rack Mount Kit rails and rail mounting hardware listed in
Table
26
power outlet. Ensure the power cable is routed so that it is not exposed to
stress.
automatically runs a Power On Self-Test (POST).
Caution: Do not connect the switch to the network until the IP address is
correctly set. For instructions on how to set the IP address, see
SAN Switch 2/32 Network
SAN Switch 2/32
Power cables
#2 Phillips screwdriver
7/16-inch wrench or socket
4.
Addressing" on page 39.
SAN Switch 2/32 Version 4.2.x Installation Guide
"Configuring