Installing The Switch As A Stand-Alone Unit - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

Installing the SAN Switch 2/8

Installing the Switch as a Stand-alone Unit

Use these procedures for setting up the switch as a stand-alone unit. The following
items are required for this setup:
1. Place the SAN Switch 2/8 on a flat, sturdy surface like a table or lab bench.
2. Apply the rubber feet as follows.
3. Connect the power cable to the SAN Switch 2/8 power supply and to a power
4. Turn on the power to the switch (flip the AC switch to "1"). The switch
Note:
instructions on how to set the IP address, see the
Network
32
SAN Switch 2/8
AC power cord and cables supplied with the switch
Rubber mounting feet supplied with the switch
Caution: Installing the rubber feet on the switch is recommended to help
prevent the switch from accidentally sliding off the table or bench.
a. Clean the four depressions that are at each corner of the bottom of the
switch to ensure they are free of dust.
b. Place a rubber foot in each depression, with the adhesive side against the
chassis, and press into place.
outlet. Ensure the power cable is routed so that it is not exposed to stress.
automatically runs a Power On Self-Test (POST).
Do not connect the switch to the network until the IP address is correctly set. For
Addressing" section on page 57.
"Configuring SAN Switch 2/8
SAN Switch 2/8 Version 3.1.x Installation Guide