Assembling The Outer Rails (Hp System/E Rack) - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

Installing the SAN Switch 2/8
Figure 19: Assembling the outer rails (HP System/e rack)
52
— For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head
screws with captive star lock washers and two #10 alignment washers in
the upper and lower hole locations of the right rail. Then install two
#10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers
and two #10 alignment washers in the upper and lower hole locations of
the left rail. See Figure 19.
SAN Switch 2/8 Version 3.1.x Installation Guide